Certificate of analysis example
Use a fictional laboratory report to practise matching a lot number, reading test results and spotting what the report leaves unanswered.
By Manchester Peptides ·
Compare the sample label with the report
Imagine a sample label that says “Reference material A, lot A-024”. The report names the same material and lot, lists a distinct document reference, and identifies the issuing laboratory. The table below is a teaching example with invented entries.
| Field | Example entry | How to read it |
|---|---|---|
| Sample and lot | Reference material A, lot A-024 | The entries match the label in this example. Confirm the documentation connecting the submitted sample to the batch. |
| Report reference | DEMO-2026-041, revision 1 | Use the report reference and revision when asking the issuer to confirm the original document. |
| Chromatographic result | Main peak, 98.4% of integrated area | The percentage describes the signal under the reported method. It gives no direct mass measurement. |
| Identity result | Measured mass consistent with the stated reference | Read the method and its scope before deciding what the result establishes. |
| Quantity | No result recorded | The amount is unknown. The peak-area percentage cannot supply it. |
What changes if the lot number differs?
If the label reads A-025 and the report reads A-024, record a traceability gap. Ask the issuer or document holder for the report that identifies A-025 or for records that explain the discrepancy. An authentic report may still describe a different sample.
Separate measured results from missing information
Check the method, units and acceptance criteria for each result. If the report has no specification for a measurement, you cannot infer a pass threshold from the number alone. A named sample report also has no bearing on clinical effectiveness or regulatory approval.
For more on the analytical methods, read the HPLC and LC–MS guide. The certificate of analysis checklist summarises what to record when comparing documents.
Common questions about certificates of analysis
What is the first thing to check on a certificate of analysis?
Match the material name, sample reference and lot number against the label or other traceable records. Then check who issued the report and when.
Is a report number the same as a lot number?
A report number identifies a document in the laboratory’s records. A lot number identifies a batch of material. The report should show how the document relates to the sample and batch.
What does an HPLC peak-area percentage mean?
It describes the relative signal assigned to a peak under the stated method. It cannot by itself establish mass fraction, quantity or the absence of substances the method cannot detect.
Can matching measured mass confirm identity on its own?
A matching mass supports an identity assignment. The strength of that conclusion depends on the method and whether it can distinguish plausible alternatives.
How should I interpret a test that is missing from a COA?
Record the result as unknown. A pass on a different test does not fill in a missing result, and a report only covers the samples and methods it identifies.
Record your conclusion in one sentence
Name the sample, the method and the result together. For this example, write that the report lists a main peak of 98.4% of integrated area for the submitted material from lot A-024.
- Use the report’s exact unit.
- Include the lot in your note.
- Record quantity separately as unknown.
